Tips for Redoing Old Dressers
If you have a plan to redo your old dresser, but need a little help doing so, you have come to right place. Continue reading this article and we will provide you a few tips to help you get the best result, so pay close attention to these steps, and you will find many tips for redoing old dressers just like a master wood finisher!
- For the very first step, something you have to do to start this project is remove any hardware from the dresser and clean it very well, your usual household cleaner can be used with no problems. And then, the dresser should be set on a tarp or plastic sheet, so your work surface can be protected. Next, make sure it is clean and dry before proceeding.
- And the second thing that you have to do is a apply a paint stripper or chemical peeler to the furniture. A disposable bristle brush can be used for this. You can simply use the paint peelers that are suitable for the type paint to completely remove it. Allow the paint peeler to sit on the surface for the time that has been recommended by the manufacturer. After that you will find a wrinkled look, and that means it is ready for removing.
- After that, the next step you have to handle is scraping away the old finish. Using a putty knife will be your best bet with this. Make sure you don’t nick the wood while you work. You can complete this by using a rounded putty knife or the plastic putty knife. Don’t gouge into the surface and keep the knife as flush as possible.
- And then, the next step you have to solve is washing all of the stripper away. Plain water or a mineral spirits can be used for this, because they are recommended by the manufacturer. Water works best for water based and the mineral spirits work with the oil based strippers. The surface should then be smoothed as you work, and fine steel wool dipped in the wash can be used for this.
- And the next step you have to solve is fill any nicks in the wood with a wood fill compound. It should then be allowed to set. This is an extra tip for redoing old dressers.
- Next, the wood’s surface should be sanded with 120-grit sandpaper and it should be worked up to 150-grit. And then, all of the sand dust should be brushed or vacuumed.
- Finally, the last step you have to complete is a stain that should be rubbed into the wood, a rag can be used for this, just ensure you are using a circular motion. When the stain rubbing has been finished, a final rub within the grain of the wood should be given, so the stain will sit in the similar direction. The stain should be allowed to sit on the wood for at least 10 minutes and then should be rubbed off by using a new cloth. Finally, the stain should be allowed to dry completely, and then the hardware should be placed back on.